|
| 貨號 | AnoLube 9620A |
| 品牌 | AnoLube 9620A |
| 是否危險化學品 | 否 |
| 產品等級 | 其他 |
| 型號 | AnoLube 9620A |
| 包裝規格 | 桶 |
| CAS編號 | |
| 純度 | 98% |
| 別名 | AnoLube 9620A |
| 密度 | 1.3g/cm3 |
| 產地/廠商 |
AnoLube 9620A Dry Film Lubricant is a lacquer-like coating containing molybdenum disulfide and corrosion inhibiting pigments. This heat-curing material prevents corrosion, seizing, galling, and fretting. It is a low-friction coating which exhibits long wear life when operated at -320 to +500°F and loads of up to 100,000 PSI.
AnoLube 9620A meets and exceeds the requirements of AS5272 (formerly Mil-L-46010D Type II)
AnoLube 9620A can be applied to a wide variety of materials by spraying or dipping.
AnoLube 9620A should be applied where maximum wear life and corrosion resistance are required.
Typical Applications
AnoLube 9620A is an excellent solution to the problem of lubricating parts:
Where parts will be operated in corrosive
atmospheres
Where fretting and galling is a problem (such as
pslines, universal joints, and keyed bearings)
Where operating pressures exceed the loadbearing
capacity of ordinary oils and greases
For parts that are seldom lubricated once they
leave the factory and where permanent, life-long
lubrication is desired
Where clean operation is desired (AnoLube
9620A will not collect dirt and dust like grease or
oil will)
Where parts are subjected to frequent disassembly
Where ease-of-release is critical (nuts and screws or PVC injection molds)
Physical Properties
| Coefficient of Friction: | ~0.0236 (Falex Test) |
| Operating Temperature: | -320°F to +500°F |
| Lubricative Pigment: | Molybdenum Disulfide |
| Vehicle Type: | Epoxy-Phenolic |
| Color/Appearance: | Flat Dark Gray |
| Wear Life: | 496 Minutes, Average (ASTM D2625 A) |
| Load Carrying Capacity: | >100,000 PSI |
| Corrosion Protection: | >1500 hours* |
